![]() ![]() This pattern shows a 3D optical illusion of the zigzag wall lit by the sun. 3 People Made This Project! glang1202 made it! mariorb made it! rockntroll made it! Did you make this project?įrom Estimated Reading Time 4 mins ![]() To finish the cutting board I put a couple of coats of butcher block oil on it. Use a 1/4" router bit around all the edges. Then sand it off and it should look pretty nice. If there are any cracks or holes, just mix some sawdust and glue together and scrape it on the spots. (I chose walnut for the trim.) Glue the trim around the cutting board on two opposite sides. Cut some wood for the trim around the cutting board. Then cut off the excess pieces to create a straight edge on the cutting board. After the glue dries, plane the cutting board down. After the glue dries on the smaller pieces, lay them out the way you want them, making sure to have them in the same pattern. Once again, this will depend on the length and width you desire your cutting board to be. After cutting all the pieces, start gluing them all together until you have enough for your cutting board. There are many different methods used to make a diamond shape out of each type of wood. I cut and planed my pieces of wood down to about 1 1/2" by 1". Plane all three types of wood to the same size. ![]() Depending on the size of the cutting board you are planning to build, you will need different lengths of wood. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |